Edit report item
This window contains parameters of individual report item. Upper part contains sorting of the item. The "Load type" ("Permanent", "Variable", "Prestress", "Accidental") defines the default value of the factor γ and also is used for the basic sorting of the report. The "Category" may be used for detailed sorting of items in the list. This parameter doesn't influence any calculation procedures. The final document may be sorted according to the type, category, load duration etc. These options are placed in the window "Report settings" (button "Report" in the toolbar).
There are three ways how to specify the load value:
Enter load | - Input of user defined item (specified manually)
|
Enter from materials catalogue | - The characteristic value of load is obtained from the catalogue of materials. This catalogue contains wide range of materials with pre-defined weight for permanent loads. Database may be extended manually by inserting user defined items. The obtained characteristic value of the load may be changed manually. The catalogue for variable loads contains loads according to the standard EN 1991-1.
|
Enter from section catalogue | - The characteristic value of load is obtained from the catalogue of cross-sections. The catalogue contains the most common steel, timber, concrete and masonry cross-sections including wide range of hot-rolled steel profiles. The characteristic value may be changed. The distribution width has to be specified, if the item is inserted into the report of type "Area". This distribution width recalculates the linear load to the area load. Analogously, load width (length of the linear member) has to be specified for items inserted into the "Point" report.
|
The load factor γF has to be specified for any item. This partial factor recalculates the characteristic values of load to design ones. The values according to the table A1.2(B) of EN 1990 (Set B) are used as a default.
Window "Edit report item"
